Sdc LRVD1R PUSH PAD (REQUEST-TO-EXIT) SWITCH KIT VON D Manuel d'utilisateur télécharger pdf

P:\INSTALLATION INST\SWITCH KITS\INST-LRVD1R.vsd REV C 06-12 Page 1

Any suggestions or comments to this instruction or

product are welcome. Please contact us through

our website or email [email protected]

LRVD1R

INSTALLATION INSTRUCTIONS

PUSH PAD (REQUEST-TO-EXIT) SWITCH KIT

VON DUPRIN 98/99-33 SERIES

Insert switch assembly into the extrusion with the back of the angle bracket against the inside

wall of the extrusion. Slide the switch assembly toward the device head until it‘s just in front of

the push bar without making contact. Locate and secure REX assembly as illustrated.

Applications

Access Control REX: Provides an authorized request-

to-exit signal to activate an access control REX input,

shunting the access control alarm output.

Magnetic Lock REX: Releases lock for uninhibited

egress when wired in series to lock power, or used to

activate a time delay trigger input to release lock for

egress.

Exit Alarm: May be used to activate an external alarm

horn located adjacent to the opening.

Remote Annunciation: Indicates door use when

connected to a remote annunciator,

RED = N/C

GRN = N/O

WHT = COM

BLK = NOT USED

3AMP @ 125VAC

RESISTIVE

REX SWITCH

ASSEMBLY

TIGHTEN DOWN SCREW

801 Avenida Acaso, Camarillo, Ca. 93012 • (805) 494-0622 •

www.sdcsecurity.com • E-mail: service@sdcsecurity.com

P:\INSTALLATION INST\SWITCH KITS\INST-LRVD1R.vsd REV C 06-12 Page 1Any suggestions or comments to this instruction or product are welcome.

Pas de commentaire

Sdc LRVD1R PUSH PAD (REQUEST-TO-EXIT) SWITCH KIT VON D Manuel d'utilisateur