Sdc LRSG1R REQUEST-TO-EXIT ELR SWITCH KIT SARGENT Manuel d'utilisateur télécharger pdf

INSTALLATION INSTRUCTIONS LRSG1R

REQUEST-TO-EXIT ELR SWITCH KIT

SARGENT

P:\INSTALLATION INST\SWITCH KIT\INST-LRSG1R.vsd REV B 03-13 Page 1

Any suggestions or comments to this instruction or

product are welcome. Please contact us through

our website or email engineer@sdcsecurity.com

801 Avenida Acaso, Camarillo, Ca. 93012 • (805) 494-0622 •

www.sdcsecurity.com • E-mail: service@sdcsecurity.com

Attach the REX switch bracket to the ELR unit with the supplied screws. Attach ELR/REX assembly to

linkage (refer to ELR Installation Instructions). Insert REX switch assembly into device under the

linkage. Depress the Push Bar to raise the pivot arm. Slide the ELR and REX assembly under the

pivot arm and secure in place by attaching the ELR to the Device base with the supplied screw (refer

to ELR Installation Instructions). Release Push Bar and make sure the pivot arm is properly

depressing the switch arm.

Linkage

Push Bar

Pivot Arm

Secure unit in place with supplied screw.

COM WHITE

N/O RED

N/C GREEN

Attach REX

to ELR

Page 1

INSTALLATION INSTRUCTIONS LRSG1RREQUEST-TO-EXIT ELR SWITCH KITSARGENTP:\INSTALLATION INST\SWITCH KIT\INST-LRSG1R.vsd REV B 03-13 Page 1 An

Pas de commentaire

Sdc LRSG1R REQUEST-TO-EXIT ELR SWITCH KIT SARGENT Manuel d'utilisateur