Sdc LR100IDCK ELECTRIC LATCH RETRACTION DEVICE KIT Manuel d'utilisateur télécharger pdf

INSTALLATION INSTRUCTIONS LR100IDCK

ELECTRIC LATCH RETRACTION DEVICE KIT

P:\INSTALLATION INST\SWITCH KITS\INST-LR100SDC.vsd REV - 08-11 Page 1

Any suggestions or comments to this instruction or

product are welcome. Please contact us through

our website or email engineer@sdcsecurity.com

Step 1

Slide the Electric Latch Retraction

assembly into device and attach

the linkage to the latch retraction

rod.

Step 2

Carefully slide the assembly

back out until the linkage JUST

makes contact with the latch

retraction rod. Tighten set

screws.

ELECTRICAL DATA

24VDC @ 500/180mA

RED (+) BLK (-)

PATENT PENDING

NOTE Retro-Fitting Vertical Rod Devices:

Before retro-fitting an electric latch assembly into a vertical device, the following must be done

to ensure proper alignment. Disconnect the vertical rods from the device. Install the electric

latch assembly as shown above. Once the ELR is properly installed energize it so that the

push pad is dogged down, by doing so it will allow for proper alignment for the vertical rods.

Finally reconnect the vertical rods to the device and make the proper adjusments.

801 Avenida Acaso, Camarillo, Ca. 93012 • (805) 494-0622 •

www.sdcsecurity.com • E-mail: service@sdcsecurity.com

SET

SCREWS

TIGHTEN SET

SCREWS TO

LOCK DEVICE

IN POSITION

Page 1

INSTALLATION INSTRUCTIONS LR100IDCKELECTRIC LATCH RETRACTION DEVICE KITP:\INSTALLATION INST\SWITCH KITS\INST-LR100SDC.vsd REV - 08-11 Page 1 A

Pas de commentaire

Sdc LR100IDCK ELECTRIC LATCH RETRACTION DEVICE KIT Manuel d'utilisateur